Cisco Cisco AP541N Wireless Access Point 설치 가이드

 

To prepare the device, do the following:

Attach the antennas to the RP-SMA connectors labeled ANT101, 
ANT102, and ANT103. The antennas are all the same, so which 
antenna is attached to what connector is of no consequence.

Determine where you want to locate the access point. If you are 
using AC power, make sure the location is within reach of an AC 
power outlet. 

Keep enough ventilation space for the access point and check for 
any other environmental restrictions.

Before you begin, you need 2 wallboard screws (included) to mount the 
access point. We recommend using screws with a minimum of 4mm width 
at the head and a shaft diameter of at least 1.5mm.

Insecure mounting might damage the device or cause injury. 
Cisco is not responsible for damages incurred by insecure wall-
mounting.

To mount the access point to the wall:

Determine where you want to mount the access point. Verify that 
the surface is smooth, flat, dry, and sturdy. 

Drill two pilot holes into the surface 5.75 inches (146 mm) apart, 
and with a minimum of 4.0 inches (101 mm) of clearance.

Insert a screw into each hole, leaving a gap between the surface 
and the base of the screw head of at least 0.1 inches (3 mm).

Place the access point wall-mount slots over the screws and slide 
the access point down until the screws fit snugly into the wall-
mount slots.