Cisco Cisco AP541N Wireless Access Point 설치 가이드

 

This section describes the process for connecting the device to power 
and the network.

Attach the power cord to the power connector and outlet (if used).

Connect a network Ethernet cable to the access point Ethernet 
port. 

Connect the other end of the Ethernet cable to your network or the 
Ethernet port of the PC you are using to configure the access point. 

DHCP is enabled by default. If a DHCP server is running on 
your network and you have not turned DHCP off, the device 
will accept a new IP address when it is connected to your 
network. You must use this IP address to configure the 
device.

To verify the hardware installation, complete the following tasks:

• Check the cable connections.

• Check the LED states, as described in the 

 section.

If you need help resolving a problem, visit the Cisco Small 
Business Support Community at 

. For technical documentation and other links, see