Cisco Cisco AP541N Wireless Access Point 관리 매뉴얼
Getting Started
Administrator Computer Requirements
7
Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide
1
NOTE
The WLAN AP is not designed to function as a gateway to the Internet. To connect
your WLAN to other LANs or the Internet, you need a gateway device.
your WLAN to other LANs or the Internet, you need a gateway device.
Administrator Computer Requirements
describes the minimum requirements for the personal computer for the
initial configuration and administration of the access point through a Access Point
Configuration Utility.
Configuration Utility.
Table 1 Requirements for Configuration
Required Software
or Component
or Component
Description
Ethernet Connection
to the Access Point
to the Access Point
The computer used to configure the access point must
be connected to the access point by an Ethernet cable.
The IP address must be on the same subnet as the
access point. The subnet mask must match the subnet
mask of the access point. The
be connected to the access point by an Ethernet cable.
The IP address must be on the same subnet as the
access point. The subnet mask must match the subnet
mask of the access point. The
these parameters on a PC running Windows.
Web Browser and
Operating System
Operating System
The following Web browsers can be used to display
the access point Configuration Utility Web pages:
the access point Configuration Utility Web pages:
•
Microsoft
®
Internet Explorer
®
version 6.x or 7.x
(with up-to-date patch level for either major
version) and Mozilla Firefox 3.x on Microsoft
Windows
version) and Mozilla Firefox 3.x on Microsoft
Windows
®
XP or Microsoft Windows 2000
•
Mozilla Firefox 3.x on Redhat
®
Linux
®
version 2.4
or later
The Web browser must have JavaScript™ enabled to
support the interactive features of the Configuration
Utility interface.
support the interactive features of the Configuration
Utility interface.
Security Settings
Ensure that security is disabled on the wireless client
used initially to configure the access point. Once the
device has been configured, security can be enabled.
used initially to configure the access point. Once the
device has been configured, security can be enabled.