Cisco Cisco WAP4410N Wireless-N Access Point - PoE Advanced Security 릴리즈 노트
Release Notes for the Cisco WAP4410N Access Point Firmware Version 2.0.7.8
7
Release Notes
•
Improved performance of “Force LAN Port Speed to 100M” option.
Changes Since WAP4410N Firmware Version VID: V01
WAP4410N now has an additional external crystal to its PHY chip for reducing
clock jitter when it works with some gigabit switches. These jitters occur during a
corner case of stressing heavy wired and wireless traffic.
clock jitter when it works with some gigabit switches. These jitters occur during a
corner case of stressing heavy wired and wireless traffic.
Changes Since WAP4410N Firmware Version 2.0.0.5
The firmware was updated and the following was fixed in firmware version 2.0.1.0.
New Field Added
The “Force LAN Port Speed to 100M” field has been added to the Advanced
Setup page. Enable this feature to force the link speed of the LAN port of the
access point to be at 100 Mbps. For example, during a corner case of stressing
heavy wired and wireless traffic with some gigabit switches, if the LAN port on a
WAP4410N access point with an earlier hardware version stops responding,
enable “Force LAN Port Speed to 100M” to resolve the issue.
Setup page. Enable this feature to force the link speed of the LAN port of the
access point to be at 100 Mbps. For example, during a corner case of stressing
heavy wired and wireless traffic with some gigabit switches, if the LAN port on a
WAP4410N access point with an earlier hardware version stops responding,
enable “Force LAN Port Speed to 100M” to resolve the issue.
Other Updates
The following updates were made:
•
Modified the field “hardware version” (in Web, Bonjour, CLI, and SNMP) to
“PID VID,” where the value can be “WAP4410N-A/E V01/02” (“WAP4410N-
A/E” depends on the bandplan of the saled regions and “V01/V02”
depends on the hardware version).
“PID VID,” where the value can be “WAP4410N-A/E V01/02” (“WAP4410N-
A/E” depends on the bandplan of the saled regions and “V01/V02”
depends on the hardware version).
•
Changed the factory default IP address configuration to DHCP. If the
WAP4410N access point does not receive a DHCP response after 60
seconds, it falls back to the following default static IP address:
WAP4410N access point does not receive a DHCP response after 60
seconds, it falls back to the following default static IP address:
192.168.1.245
•
Changed SBBU to ciscosb in the mib file.
•
Added DHCPv6 client support.
•
Added Bonjour protocol support.