Cisco Cisco WAP121 Wireless-N Access Point with Single Point Setup 설치 가이드

The front panel of the devices consists of three lights: Power, WLAN, and 
LAN. For full descriptions of the colors of the lights and their indications, 
see 

. A Kensington lock slot is found 

under the lights.

The back panel of the devices consists of:

• Power Button—Use this button to turn the power on and off. It is not 

applicable when using PoE.

• Power Jack—Use this jack if you are not using PoE.

• Kensington Lock Slot—Use to attach a cable and lock to the device. 

• Reset—See 

 for information on the Reset button.

• RJ-45 Ethernet Port—Use this auto-sensing, Gigabit Ethernet (802.3) 

port to connect to network devices, such as computers, routers, or 
switches. Cisco strongly recommends using Cat5e or better cable 
for Gigabit connectivity. You may use the Ethernet port to power your 
device using PoE.

If you are using a Cisco RV Series router, the default range for the DHCP 
assigned address is from 192.168.1.100 to 192.168.1.254. Any device 
connecting to the same LAN will be assigned an IP address in this range.

Username

cisco 

Password

cisco

LAN IP Address 

DHCP address assigned 
by server

Fallback LAN IP

192.168.1.245

Subnetwork Mask

255.255.255.0