Cisco Cisco Aironet 1260 Access Point
4-11
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
Chapter 4 Configuring the Access Point for the First Time
Assigning Basic Settings
–
For the 2.4 GHz radio, the relevant options are Least-Congested, channel 1-2412, channel
2-2417, channel 3-2422, channel 4-2427, channel 5-2432, channel 6-2437, channel 7-2442,
channel 8-2447, channel 9-2452, channel 10-2457, and channel 11-2462.
2-2417, channel 3-2422, channel 4-2427, channel 5-2432, channel 6-2437, channel 7-2442,
channel 8-2447, channel 9-2452, channel 10-2457, and channel 11-2462.
–
For the 5 GHz radio, the relevant options are Dynamic Frequency selection, channel 36-5180,
channel 40-5200, channel 44-5220, channel 48-5240, channel 149-5745, channel 153-5765,
channel 157-5785, channel 161-5805, and channel 165-5825.
channel 40-5200, channel 44-5220, channel 48-5240, channel 149-5745, channel 153-5765,
channel 157-5785, channel 161-5805, and channel 165-5825.
•
Power—Choose the power level from the Power drop-down list.
–
For the 2.4 GHz radio, the relevant options are Maximum, 22, 19, 16, 13, 10, 7, and 4.
–
For the 5 GHz radio, the relevant options are Maximum, 14, 11, 8, 5, and 2.
Step 9
Click Apply to save your settings.
Step 10
Click Network Interfaces to browse to the Network Interfaces Summary page.
Step 11
Click the radio interface to browse to the Network Interfaces: Radio Status page.
Step 12
Click the Settings tab to browse to the Settings page for the radio interface.
Step 13
Click Enable to enable the radio.
Step 14
Click Apply.
Your wireless device is now running but probably requires additional configuring to conform to your
network operational and security requirements. Consult the chapters in this manual for the information
you need to complete the configuration.
network operational and security requirements. Consult the chapters in this manual for the information
you need to complete the configuration.
Note
You can restore 1040, 1140, 1240, 1250 and 1260 series access points to factory defaults by
unplugging the power jack and plugging it back in while holding down the Mode button for a
few seconds, or until the Status LED turns amber.
unplugging the power jack and plugging it back in while holding down the Mode button for a
few seconds, or until the Status LED turns amber.
Default Settings on the Easy Setup Page
Table 4-1
Default Settings on the Express Setup Page
Setting
Default
Host Name
ap
Configuration Server Protocol
DHCP
IP Address
Assigned by DHCP by default; see the
for a description of default IP
address behavior on the access point
IP Subnet Mask
Assigned by DHCP by default; if DHCP is disabled, the default
setting is 255.255.255.224
setting is 255.255.255.224
Default Gateway
Assigned by DHCP by default; if DHCP is disabled, the default
setting is 0.0.0.0
setting is 0.0.0.0
IPv6 Protocol
DHCP and Autoconfig
SNMP Community
defaultCommunity (Read-only)