Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 관리 매뉴얼
6
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
105
System Security
This chapter describes how to configure security settings on the WAP device device.
It contains these topics:
•
•
•
•
RADIUS Server
Several features require communication with a RADIUS authentication server. For example,
when you configure Virtual Access Points (VAPs) on the WAP device, you can configure
security methods that control wireless client access (see the
when you configure Virtual Access Points (VAPs) on the WAP device, you can configure
security methods that control wireless client access (see the
page). The Dynamic WEP
and WPA Enterprise security methods use an external RADIUS server to authenticate clients.
The MAC address filtering feature, where client access is restricted to a list, may also be
configured to use a RADIUS server to control access. The Captive Portal feature also uses
RADIUS to authenticate clients.
The MAC address filtering feature, where client access is restricted to a list, may also be
configured to use a RADIUS server to control access. The Captive Portal feature also uses
RADIUS to authenticate clients.
You can use the Radius Server page to configure the RADIUS servers that are used by these
features. You can configure up to four globally available IPv4 or IPv6 RADIUS servers;
however, you must select whether the RADIUS client operates in IPv4 or IPv6 mode with
respect to the global servers. One of the servers always acts as a primary while the others act as
backup servers.
features. You can configure up to four globally available IPv4 or IPv6 RADIUS servers;
however, you must select whether the RADIUS client operates in IPv4 or IPv6 mode with
respect to the global servers. One of the servers always acts as a primary while the others act as
backup servers.
NOTE
In addition to using the global RADIUS servers, you can also configure each VAP to use a
specific set of RADIUS servers. See the
specific set of RADIUS servers. See the
page.
To configure global RADIUS servers: