Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 관리 매뉴얼
8
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
129
Simple Network Management Protocol
This chapter describes how to configure the Simple Network Management
Protocol (SNMP) to perform configuration and statistics gathering tasks.
Protocol (SNMP) to perform configuration and statistics gathering tasks.
It contains these topics:
•
•
•
•
•
General SNMP Settings
You can use the General page to enable SNMP and configure basic protocol
settings.
settings.
To configure general SNMP settings:
STEP 1
Select SNMP > General in the navigation pane.
STEP 2
Select Enabled for the SNMP setting. SNMP is disabled by default.
STEP 3
Specify a UDP Port for SNMP traffic.
By default, an SNMP agent listens only to requests from port 161. However, you
can configure this so that the agent listens to requests on a different port. The valid
range is from 1025 to 65535.
can configure this so that the agent listens to requests on a different port. The valid
range is from 1025 to 65535.
STEP 4
Configure the SNMPv2 settings:
•
Read-only Community—A read-only community name for SNMPv2
access. The valid range is 1 to 256 alphanumeric and special characters.
access. The valid range is 1 to 256 alphanumeric and special characters.