Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 설치 가이드

Insecure mounting might damage the device or cause injury. 
Cisco is not responsible for damages incurred by insecure wall 
or ceiling mounting.

To mount the Cisco WAP 571 device to a wall or ceiling:

Determine where you want to mount the device. Verify that the 
surface is smooth, flat, dry, and sturdy. 

Drill two pilot holes into the surface 2.75 inches (70 mm) apart for 
your Cisco WAP device. 

Insert a screw into each hole, leaving a gap between the surface 
and the base of the screw head.

Place the upper slots of the bracket over the screws, adjust the 
screws accordingly, and slide the bracket down until the screws fit 
snugly into the slots.

Using the bracket as a template, drill two more holes for the lower 
screws.

Insert a screw into each lower hole.

Slide the WAP device into the bracket, placing the cable through 
the break-out tab found in the back of the bracket. 

The WiFi default SSID is “Cisco SB-Setup” with the passphrase “cisco123” 
in WPA2-PSK AES. This wireless default configuration will not allow traffic 
between WiFi and Ethernet; users will need to go through the setup wizard 
to resume the traffic between WiFi and Ethernet.

The user can also perform the initial configuration using a wired Ethernet 
connection. 

To connect the device to the wired network:

Connect the Ethernet cable to the Ethernet port of a PoE switch. 

Connect the other end of the network Ethernet cable to the 
Ethernet port (PoE) of the wireless access point.