Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 설치 가이드

The front panel of the device consists of a single system LED. For a full 
description of the colors of the light and its indications, see 

.

A Kensington lock slot is found above the light.

The back panel of the device has two RJ-45 Ethernet ports. Facing the 
back of the device, the right port (labeled “ETH0/PD”) is an 802.3at & 
802.3af Power over Ethernet (PoE) port which is used to power your 
device. The left port (labeled “ETH1”) is a general Gigabit Ethernet LAN 
interface. Both are auto-sensing, Gigabit Ethernet (802.3) ports used to 
connect your WAP devices to network devices, such as computers, 
routers, or switches. We strongly recommend that you use a Category 
5e or better cable for Gigabit connectivity.

The side panel of the device has a Reset button. See 

 

for information on the Reset button.

If you are using a Cisco RV Series router, the default range for the DHCP 
assigned address is from 192.168.1.100 to 192.168.1.254. Any device 
connecting to the same LAN will be assigned an IP address in this range.

If your network does not have an existing DHCP server, the WAP571 will 
start a DHCP server for WLAN stations and stop the DHCP client when 
WAP571 is in factory default. The DHCP server will assign the IP address 
from 192.168.1.20 to 192.168.1.100.

Username

cisco

Password

cisco

LAN IP Address

DHCP address assigned 
by server

Fallback LAN IP

192.168.1.245

Subnetwork Mask

255.255.255.0