Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 관리 매뉴얼
Single Point Setup
Single Point Setup Overview
Cisco WAP571/E Administration Guide
170
12
Managing Single Point Setup Across Access Points
Single Point Setup creates a dynamic, configuration-aware cluster, or group, of
WAP devices in the same subnet of a network. A cluster supports a group of up to
16 configured WAP571/E devices, but no other non-WAP571/E models in the
same cluster.
WAP devices in the same subnet of a network. A cluster supports a group of up to
16 configured WAP571/E devices, but no other non-WAP571/E models in the
same cluster.
Single Point Setup allows the management of more than one cluster in the same
subnet or network; however, they are managed as single independent entities.
The table shows Single Point Setup wireless service limits.
subnet or network; however, they are managed as single independent entities.
The table shows Single Point Setup wireless service limits.
A cluster can propagate configuration information, such as VAP settings, QoS
queue parameters, and radio parameters. When you configure Single Point Setup
on a device, settings from that device (whether they are manually set or set by
default) are propagated to other devices as they join the cluster.
queue parameters, and radio parameters. When you configure Single Point Setup
on a device, settings from that device (whether they are manually set or set by
default) are propagated to other devices as they join the cluster.
To form a cluster, make sure the following prerequisites or conditions are met:
STEP 1
Plan your Single Point Setup cluster. Be sure the two or more WAP devices you
want to cluster are compatible with each other. For example, Cisco WAP571/E
devices can only cluster with other Cisco WAP571/E devices.
want to cluster are compatible with each other. For example, Cisco WAP571/E
devices can only cluster with other Cisco WAP571/E devices.
NOTE
It is strongly recommended to run the latest firmware version on all clustered
WAP devices. Firmware upgrades are not propagated to all WAP devices in a
cluster; you must upgrade each device independently.
cluster; you must upgrade each device independently.
STEP 2
Set up the WAP devices that will be clustered on the same IP subnet and verify
that they are interconnected and accessible across the switched LAN network.
that they are interconnected and accessible across the switched LAN network.
STEP 3
Enable Single Point Setup on all WAP devices. See
.
STEP 4
Verify that the WAP devices all reference the same Single Point Setup name. See
Group/Cluster
Type
Type
WAP Devices
per Single Point
Setup
per Single Point
Setup
Number of
Active Clients
per Single Point
Setup
Active Clients
per Single Point
Setup
Maximum
Number of
Clients (Active
and Idle)
Number of
Clients (Active
and Idle)
WAP571/E
16
960 for the
WAP571/E with a
dual radio
WAP571/E with a
dual radio
2048 for the
WAP571/E with a
dual radio
WAP571/E with a
dual radio