Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 관리 매뉴얼
4
Cisco WAP571/E Administration Guide
63
LAN
This section describes how to configure the port, VLAN, IPv4, and IPv6 settings of
the WAP device.
the WAP device.
It includes these topics:
•
•
•
•
•
•
Port Settings
Use the Port Settings page to view and configure the settings for the port that
physically connects the WAP device to a local area network.
physically connects the WAP device to a local area network.
To configure the port settings:
STEP 1
Select LAN > Port Settings.
The Port Settings Table includes the following status and configurations for two
Interfaces (Eth0 to Eth1):
Interfaces (Eth0 to Eth1):
•
Link Status—Shows the current port link status.
•
Port Speed—In review mode, it shows the current port speed. In edit mode,
if Auto Negotiation is disabled, select a port speed such as 100 Mbps or 10
Mbps. 1000 Mbps speed is only supported through Auto-Negotiation
enabled).
if Auto Negotiation is disabled, select a port speed such as 100 Mbps or 10
Mbps. 1000 Mbps speed is only supported through Auto-Negotiation
enabled).