Cisco Cisco Aironet 1200 Access Point 릴리즈 노트

1200 series repeater access points running Cisco IOS software cannot associate to parent access points 
that do not run IOS software (1200 series access points that have not been converted to run IOS 
software).

Repeater access points can participate in WDS but they cannot provide WDS. You cannot configure a 
repeater access point as a main WDS access point, and if a root access point becomes a repeater in 
fallback mode, it cannot provide WDS.

If you change the speed and duplex settings from auto to fixed on an 1100 series access point’s Ethernet 
port, the auto-MDIX feature on the port is disabled. When auto-MDIX is disabled, you must determine 
whether to use a straight-through or a crossover cable to connect the access point Ethernet port to another 
device. If the Ethernet link goes down after you set the speed and duplex to fixed, try changing the 
Ethernet cable from crossover to straight-through or from straight-through to crossover.

The link test feature on the web-browser interface does not support non-Cisco Aironet client devices nor 
Cisco Aironet 802.11g client devices.

When the Ethernet port is disabled on an 1100 series access point running boot loader version 12.2(4)JA, 
the access point boots into monitor mode when it reboots. To avoid this problem, connect the access 
point Ethernet port to one of the following:

a wired LAN

the Ethernet port on a PC

Remove power from the access point and reapply power to reboot the unit. When the access point senses 
an Ethernet connection, it boots normally.