Cisco Cisco Aironet 1200 Access Point 릴리즈 노트

You must use a Wireless LAN Services Module (WLSM) as your WDS device in order to properly 
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not 
support Layer 3 mobility, client devices cannot associate using that SSID.

This section lists open and resolved caveats for access points.

These caveats are open in Cisco IOS Release 12.3(8)JEB:

CSCek46661—VLAN assignment fails when using local radius server.

After passing EAP-FAST authentication, the client is not placed into the VLAN defined by the group 
configured in the local RADIUS server. Instead, the client remains in the VLAN assigned by the 
SSID.

CSCsc83206—A nested repeater access point fails to notify radar detection

If radar is detected on a nested repeater in a nested repeater chain, no action is being taken by either 
the repeater or root/parent to notify the detection.

CSCsc94510—GUI can set illegal combination of Low Latency Rates

The GUI can set an illegal combination of low latency rates on the access point. Rates of 48 and 
54Mbps set as both nominal and non-nominal can occur. Once the rates are set, you can not disable 
them and they stay set as non-nominal.

CSCsd69733—Hot standby access point cannot associate

The hot standby access point almost always fails to authenticate with the error cannot associate: Not 
standby parent (from incorrect mac address. The incorrect mac address is the mac address of another 
access point on the same network but not its parent device's mac address. In other words, the hot 
standby unit attempts to authenticate with an access point that is not it's parent and fails.

CSCse34644—Shared authentication with a non-native vlan does not operate properly