Cisco Cisco Aironet 702W Access Point 설치 가이드

Installing the access point involves these operations:

Performing a pre-installation configuration (optional)

Mounting the access point

Deploying the access point on the wireless network

The following procedures ensure that your access point installation and initial operation go as expected. A pre-installation 
configuration is also known as priming the access point. This procedure is optional.

Performing a pre-installation configuration is an optional procedure. If your network controller is properly configured, 
you can install your access point in its final location and connect it to the network from there. See the 

 for details.

The pre-installation configuration setup is shown in 

.

To perform pre-installation configuration, perform the following steps:

Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use the CLI, web-browser 
interface, or Cisco Prime Infrastructure procedures as described in the appropriate Cisco wireless LAN controller guide.

Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller Management.

Configure the switch to which your access point is attach to. See the Cisco Unified Wireless Network WLAN Controller 
Configuration Guide for additional information.

Set the Cisco wireless LAN controller as the master so that new access points always join with it.

Controller

Layer 3

devices

Cisco Aironet

access points

272488