Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
6
Release Notes for Cisco Aironet 1200 Series Access Points Running VxWorks Firmware Version 12.03T
OL-4157-01
Limitations and Restrictions
EAP Authentication Requires Matching 802.1x Protocol Drafts
Note
This section applies to wireless networks set up to use LEAP. If you do not use LEAP on your wireless
network, you can skip this section.
network, you can skip this section.
Wireless client devices use Extensible Authentication Protocol (EAP) to log onto a network and generate
a dynamic, client-specific WEP key for the current logon session. If your wireless network uses WEP
without EAP, client devices use the static WEP keys entered in the Aironet Client Utilities.
a dynamic, client-specific WEP key for the current logon session. If your wireless network uses WEP
without EAP, client devices use the static WEP keys entered in the Aironet Client Utilities.
If you use Network-EAP authentication on your wireless network, your client devices and access points
must use the same 802.1x protocol draft. For example, if the radio firmware on the client devices that
will associate with an access point is version 4.16, the access point should be configured to use Draft 8
of the 802.1x protocol.
must use the same 802.1x protocol draft. For example, if the radio firmware on the client devices that
will associate with an access point is version 4.16, the access point should be configured to use Draft 8
of the 802.1x protocol.
lists firmware versions for Cisco Aironet products and the draft with
which they comply.
Use the Authenticator Configuration page to select the draft of the 802.1x protocol the access point
should use. Follow these steps to set the draft for your access point:
should use. Follow these steps to set the draft for your access point:
Step 1
Browse to the Authenticator Configuration page in the access point management system:
a.
On the Summary Status page, click Setup.
b.
On the Setup page, click Security.
c.
On the Security Setup page, click Authentication Server.
Table 1
802.1x Protocol Drafts and Compliant Client Firmware
Firmware Version
Draft 7
Draft 8
802.1x-2001
PC/PCI cards 4.13
—
x
—
PC/PCI cards 4.16
—
x
—
PC/PCI cards 4.23
—
x
—
PC/PCI cards 4.25 and later
—
—
x
WGB34x/352 8.58
—
x
—
WGB34x/352 8.61 and later
—
—
x
AP34x/35x 11.05 and earlier
—
x
—
AP34x/35x 11.06 and later
1
1.
The default draft setting in access point VxWorks firmware version 11.06 and later is
802.1x-2001.
802.1x-2001.
—
x
x
AP34x/35x 11.07 and later
—
x
x
AP12xx 11.40T and later
—
x
x