Cisco Cisco Aironet 1200 Access Point 릴리즈 노트

Click Browse to browse to the upgrade image file and select it.

Click Browser Update Now. The upgrade process begins. 

When the upgrade completes, a message appears that asks you to wait 30 seconds for the access point to 
reboot. After it reboots, the access point runs IOS software. To access your IOS access point, browse to 
the access point and enter Cisco as the administrator username and Cisco as the password.

This section describes important information about access points running IOS software. For more 
information on Cisco IOS releases for access points, refer to the release notes for specific releases.

When a Cisco Aironet client device associates to a 1200 series access point running IOS software, the 
access point MAC address that appears on the Status page in the Aironet Client Utility (ACU) is the 
MAC address for the access point radio. The MAC address for the access point Ethernet port is printed 
on the label on the back of the access point.

When a client device roams from an access point (such as access point alpha) to another access point 
(access point bravo), a message appears in the event log on access point alpha stating that the client 
roamed to access point bravo. The MAC address that appears in the event message is the MAC address 
for the radio in access point bravo instead of the Ethernet port in access point bravo.

Access points that do not run IOS software (340 and 350 series access points) cannot serve as parents 
for repeater access points that run IOS software.

For the most up-to-date, detailed troubleshooting information, refer to the Cisco TAC website at 

. Click Technology Support, select Wireless from 

the menu on the left, and click WLAN (Wireless, LAN).