Cisco Cisco Broadband Access Center Telco Wireless 3.10
6-10
Cisco Broadband Access Center for Cable Administrator’s Guide
OL-2445-02
Chapter 6 Configuring and Using the Sample User Interface
Sample sampleui.properties File
Step 7
Save those changes back into the sampleui.properties file.
Modification Checklist
The checklist shown in
identifies the sampleui.properties parameters that can be changed.
Sample sampleui.properties File
This section identifies the contents of a sample sampleui.properties file. This properties file is located
in the <BPR_HOME>/rdu/conf directory.
in the <BPR_HOME>/rdu/conf directory.
Table 6-1
Parameters Requiring Change
Parameter
Description
adminuser
Identifies the real administrative user’s login name for the RDU.
adminpass
Identifies the real administrative user’s password for the RDU.
host
Identifies the fully qualified domain name (FQDN) or the IP address of the
computer that runs the RDU. This will typically be localhost.
computer that runs the RDU. This will typically be localhost.
port
Identifies the port number for the RDU computer. Unless changed during
installation, the default value is 49187.
installation, the default value is 49187.
user
Identifies the properties controlling authentication information that are
accepted for the sample administrator pages and the technician login.
accepted for the sample administrator pages and the technician login.
•
techprovisioning.enabled—This is the controlling property when
technician provisioning is enabled. When enabled, the self-provisioning
flow is altered to provide login prompts before the device is registered. If
this is disabled, the interface will prohibit device registration.
technician provisioning is enabled. When enabled, the self-provisioning
flow is altered to provide login prompts before the device is registered. If
this is disabled, the interface will prohibit device registration.
•
techprovisioning.authentication—This is the controlling property when
technician provisioning, requiring credential authentication, is used. If
required, this will make the login authenticate against the users registered
in sampleui.properties. If disabled, this will let anybody perform
self-provisioning.
technician provisioning, requiring credential authentication, is used. If
required, this will make the login authenticate against the users registered
in sampleui.properties. If disabled, this will let anybody perform
self-provisioning.
service
Identifies and defines classes of service that are displayed by the sample
provisioning workflow.
provisioning workflow.
Note
If a single class of service is defined, the controls to select a class of
service are not displayed.
service are not displayed.
computerisp
Defines the ISPs to be listed when registering computers. If only one ISP is
defined, no ISP selection options will be shown in the demo.
defined, no ISP selection options will be shown in the demo.
disabled
Controls configurable options on a disabled device.
#
(C) Copyright 2001-2003 by Cisco Systems, Inc.
#
This program contains proprietary and confidential information.
#
All rights reserved. This software shall not be used by an party