Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Setting up Input Information
OL-29015-01
147
Setting up the ASI Input
1 From the user interface of the D9824, choose Input > Input Setup. The Input
Setup page is displayed.
2 Click on the ASI tab.
3 Check the Use ASI Input check box to tune to the ASI input.
Note: Setting a new input to be active will deactivate the currently active input.
4 Click Apply.
The ASI Input Status area displays the current ASI status. The following table
describes the ASI Input Status information displayed:
describes the ASI Input Status information displayed:
Parameter
Description
Active Input
Indicates the currently selected input source (RF1, RF2, RF3,
RF4, ASI, or IP).
RF4, ASI, or IP).
Signal Status
Indicates whether the input signal is locked.
Locked - Indicates the receiver is locked to a carrier
with no valid content.
with no valid content.
Lock+Sig - Indicates the receiver is locked to a carrier
with valid content.
with valid content.
No Lock - Indicates the receiver is not locked to a
carrier.
carrier.
Input Rate (Mbps)
Displays the bit rate of the input transport stream, in Mbps.