Cisco Headend System Release 2.7 설치 가이드
740223 Rev F
9
Introduction
The Session-Based Encryption (SBE) activation process involves five
phases that span seventeen days.
On Day One, Cisco Services engineers perform the SBE activation
On Day One, Cisco Services engineers perform the SBE activation
phase tasks. The four additional SBE set-up phases include procedures
you perform on Days Two, Five, Ten, and Seventeen. The length of
time between each phase lets you measure the system database
progress to ensure that type 8 EMMs are being generated.
Note: The actual amount of time needed to complete each process
Note: The actual amount of time needed to complete each process
within a phase will vary depending on the size of the site and the
complexity of the system.
This chapter details the procedures that must be completed to activate
This chapter details the procedures that must be completed to activate
SBE on your system.
Before You Begin
On the last day (seventeen), you must use the VOD Information
diagnostic screen to verify that a DHCT has received type 8 EMMs.
This step cannot be performed on DHCTs that do not support the
SA Resident Application (SARA).
Important: If your DHCTs are supported by a resident application
Important: If your DHCTs are supported by a resident application
other than SARA, contact your vendor to see if there is a similar
verification procedure to determine that the DHCTs have received
type 8 EMMs.
2
Chapter 2
Activate SBE