Cisco Model 6109 6 MHz Off-Air Reference (NTSC) 설치 가이드
USRM Initial Setup and Startup
78-4021139-01 Rev D
311
2 Set three fields in this new file for each new route on the interface: GATEWAY,
NETMASK, and ADDRESS. (Each field should have a number appended to it to
designate its associated route.) Here is an example of a file which sets to static
routes on eth0:
/etc/sysconfig/network-scripts/route-eth0
/etc/sysconfig/network-scripts/route-eth0
GATEWAY0=10.0.0.1
NETMASK0=255.0.0.0
ADDRESS0=10.0.0.0
GATEWAY1=10.0.1.1
NETMASK1=255.255.255.0
ADDRESS1=192.168.1.0
3 Save the modified file and either reboot the system or restart networking by
entering:
service network restart
Controlling the USRM Watchdog
The USRM uses a watchdog application to monitor up time and to manage the
upgrading of the USRM. Once the USRM software is installed, the watchdog starts
automatically on boot.
Important: The watchdog never needs to be shut down or restarted. The following
Important: The watchdog never needs to be shut down or restarted. The following
section is for system maintenance only and should never be required during normal
system operation.
Note: If you start the watchdog manually, it will not start the USRM. Once the
Note: If you start the watchdog manually, it will not start the USRM. Once the
watchdog has been started, you can start the USRM manually. From that point on,
the watchdog will monitor the USRM.
The watchdog can be manually stopped and started using the tnoswdog startup
The watchdog can be manually stopped and started using the tnoswdog startup
script located in the /etc/init.d directory. Type the script command, with desired
option, at the system prompt and press Enter.
The script can be run with the following options:
The script can be run with the following options:
Script and Option
Function
/etc/init.d/tnoswdog start
Starts the watchdog.
/etc/init.d/tnoswdog stop
Stops the watchdog. The USRM continues
to run but the watchdog no longer
maintains it.
/etc/init.d/tnoswdog restart
Restarts the watchdog.
/etc/init.d/tnoswdog status
Displays the status of the watchdog. The
status displays whether the watchdog was
previously started or stopped.