Cisco Model 6109 6 MHz Off-Air Reference (NTSC) 설치 가이드
UCS USRM Initial Setup and Startup
78-4021139-01 Rev D
313
UCS USRM Initial Setup and Startup
Accessing the USRM
The USRM can be accessed by any of the following methods:
Monitor, Keyboard, and Mouse: If you connect a monitor, keyboard, and a
mouse (optional) to the USRM, you will get a Linux login prompt on boot up.
Serial Console: The USRM has a serial console available via the serial port on
the back panel. To access it, attach a null-modem serial cable between the USRM
and a PC. On the client PC, set the serial port speed to 9600 baud. When you
connect, you will see a Linux login prompt.
Secure Shell Network Login: If the network you first attach the USRM to has a
DHCP server, you can use SSH to access the system remotely from any computer
with an SSH client. You need to know the USRM's IP address to log on via this
method.
UCS USRM Setup Procedure
Important: The operating system and the UCS USRM software come pre-installed.
This condition is a prerequisite for first time setup. If these software components are
not installed, refer to OS Recovery, Software Re-Installation & Upgrade (on page
403) for instructions on re-installing the software.
Running the UCS USRM Setup Script
Follow these steps to setup and configure the USRM.
1 Log in to the USRM as user "root" using the default password "generic".
2 Type the following command at the system prompt and press Enter:
Follow these steps to setup and configure the USRM.
1 Log in to the USRM as user "root" using the default password "generic".
2 Type the following command at the system prompt and press Enter:
cd /opt/usrm
Note: Be sure to include the space in the command.
3 Type the following command at the system prompt and press Enter:
./setup_ucs_usrm.sh
4 Answer the following on-screen questions to set up the network and USRM for
your particular environment.
Note: If you make an incorrect entry during step 4, press CTRL - C and start over
Note: If you make an incorrect entry during step 4, press CTRL - C and start over
at step 3. The letters next to the questions are for reference only and do not
appear on screen.