Cisco Prisma II 1310 nm HDTx Transmitters 설치 가이드
Appendix A
Module Parameter Descriptions
104
Transmitter Module Parameters
Operating Status Parameters
Parameter
Name (LCI)
Name (LCI)
ICIM
Abbreviation
Abbreviation
Function
Typical Value
Optical Output
Power
Power
OutPwr
Displays optical output power.
Depends on the
transmitter
output, typically
0.2 - 0.3dBm
greater than the
rated power.
transmitter
output, typically
0.2 - 0.3dBm
greater than the
rated power.
Laser Bias
Current
Current
LasBias
Displays laser bias current.
69 mA
RF Input
Power
Power
InRF
Displays RF input level.
0.0 dB
Module
Temperature
Temperature
ModTemp
Displays module temperature.
34.5 °C
TEC Current
TecCur
Displays laser thermoelectric cooler
current.
current.
88.2 mA
Laser
Temperature
Temperature
LasTemp
Displays laser temperature.
29.2 °C
Laser RF Drive
LasRF
Indicates RF drive level at laser
input reference to nominal setup.
input reference to nominal setup.
0.0 dB
Enable Laser
Enable
Status of laser (On or Off).
On
CW Mode
CwMode
Status of continuous wave mode
operation (On or Off).
operation (On or Off).
Off
Low RF Alarm
Inhibit
Inhibit
LoRFInh
Status of Low RF alarm (On or Off). Off
Master
Master
Indicates Master or Slave mode
operation.
operation.
Master
RF Drive Level RFDrive
Displays RF drive level relative to
nominal setup.
nominal setup.
-5.0 dB – 3.0 dB
AGC
AGC
Status of automatic gain control
(On or Off).
(On or Off).
On
Note: Monitored values may vary from module to module. The values shown above
are examples only.
are examples only.