Cisco Prisma II 1310 nm HDTx Transmitters 설치 가이드
Transmitter Module Parameters
105
Configurable Parameters
Parameter
Name (LCI)
Name (LCI)
ICIM
Abbreviation
Abbreviation
Description
Values
Default
Enable Laser
Enable
Enables or disables amplifier
operation, i.e., turns the laser on or
off.
operation, i.e., turns the laser on or
off.
ON (1) = Enabled
OFF (0) =
Disabled
OFF (0) =
Disabled
OFF (0)
CW Mode
CwMode
Automatically adjusts the
displayed RF input level by
subtracting 3 dB when CW mode
is on.
displayed RF input level by
subtracting 3 dB when CW mode
is on.
ON (1) = Enabled
OFF (0) =
Disabled
OFF (0) =
Disabled
OFF (0)
Low RF Alarm
Inhibit
Inhibit
LoRFInh
Enables or disables the "RF input
low" alarm.
low" alarm.
ON (1) = Alarm
Enabled
Enabled
OFF (0) = Alarm
Disabled
Disabled
ON (1)
Master
Master
Configures the module as master
or slave:
or slave:
If set to Master, the transmitter
is controlled only by the
Enable control above.
is controlled only by the
Enable control above.
If set to Slave, the transmitter
is controlled by a combination
of Enable and the external
input CNT_IN_1.
is controlled by a combination
of Enable and the external
input CNT_IN_1.
ON (1) = Master
OFF (0) = Slave
OFF (0) = Slave
ON (1)
RF Drive Level
RFDrive
Sets the relative RF drive level into
the transmitter.
the transmitter.
-5.0 dB to +3.0 dB
in 0.5 dB steps
in 0.5 dB steps
0.0 dB
AGC
AGC
Turns automatic gain control on or
off.
off.
ON (1)
OFF (0)
OFF (0)
OFF (0)