Cisco Cisco IP Contact Center Release 4.6.1 설치 가이드

Note the following differences among the four forms:

• With Packet Scheduler there are only two priority levels (High and Low)—the Medium

Priority traffic is marked the same as the Low Priority traffic.

• Bandwidth settings are not enabled on Side B because that information is obtained from Side

A.

• The Select Network Interface Card list is used only with Packet Scheduler, in which case a

Card must be selected from the display of available Cards.

• When using Packet Scheduler, the same DSCP and 802.1p settings must be used for every

ICM instance that uses a given Network Interface Card. Record the settings you use to make
sure that this rule is followed.

• When not using Packet Scheduler, the Side B dialog box has no fields enabled because that

information is obtained from Side A.

Click OK, which accepts the information that you entered, and returns you to the Peripheral
Gateway Network Interfaces dialog box.

For the Peripheral Gateway Network Interfaces dialog box, 

.

How to Set the QoS Feature for the PG Visible Interfaces

In the PG Visible Link QoS Settings dialog box, check Use Packet Scheduler if you plan to use
Microsoft Packet Scheduler.

Leave Use Packet Scheduler unchecked if you do not plan to use Microsoft Packet Scheduler.

Select DSCP priority markings and 802.1p priority tagging, and enter Bandwidth information,
as appropriate and allowed—if Packet Scheduler is used, Setup checks that Total Usable
Bandwidth (kbps) for Side A and Side B is at least 56 each and that the Bandwidth Percent
values add up to 100.

With Packet Scheduler there are only two priority levels (High and Low)—the Medium Priority
traffic is marked the same as the High Priority traffic.

Click OK, which accepts the information that you entered, and returns you to the Peripheral
Gateway Network Interfaces dialog box.

For the Peripheral Gateway Network Interfaces dialog box, 

.

ICM Installation Guide for Cisco ICM Enterprise Edition Release 7.0(0)