Cisco Cisco IP Contact Center Release 4.6.1 설치 가이드

다운로드
페이지 115
See Also
For Router interfaces, 
. For the PG
Private Link QoS Settings dialog box, 
. For the PG Visible Link QoS Settings dialog box, 
. For the Check Setup Information window
How to Set the QoS Feature for the PG Private Interfaces
The PG Private Link QoS Settings dialog box comes in two forms.
If you are installing the PG on Side A of a duplexed system, or you are installing the PG on
a simplexed system, you see the PG Private Link QoS Settings (Side A) dialog box.
If you are installing the PG on Side B of a duplexed system, you see the PG Private Link
QoS Settings (Side B) dialog box.
Further, the precise nature of the Side A and Side B forms depends on whether you use Microsoft
Packet Scheduler or not; that is, there are actually four forms.
Step 1
In the PG Private Link QoS Settings (Side A) dialog box, check Enable QoS. (There is no
Enable QoS box in the PG Private Link QoS Settings (Side B) dialog box. QoS is enabled on
Side B if, and only if, it is enabled on Side A.)
Step 2
Check Use Packet Scheduler if you plan to use Microsoft Packet Scheduler.
Leave Use Packet Scheduler unchecked if you do not plan to use Microsoft Packet Scheduler.
If Use Packet Scheduler is checked for Side A, it must be checked for Side B.
If Use Packet Scheduler is unchecked for Side A, it must be unchecked for Side B.
Note: Cisco recommends NOT implementing Microsoft Packet Scheduler for ICM 7.0(0). For
more information about ICM QoS, and about this recommendation in particular, refer to the
Pre-Installation Planning Guide for Cisco ICM Enterprise Edition. If you plan to use Microsoft
Packet Scheduler you must install it separately—it is not installed from ICM Setup.
Step 3
Select DSCP priority markings and 802.1p priority tagging, and enter Bandwidth information,
as appropriate and allowed—if Packet Scheduler is used, Setup checks that Total usable
bandwidth (Kbps)
 is at least 1544 and that the Bandwidth Percent values add up to 100.
ICM Installation Guide for Cisco ICM Enterprise Edition Release 7.0(0)
66
Peripheral Gateway Setup
How to Install a Peripheral Gateway