Brother RJ-2030 빠른 설정 가이드

To stop the battery charging, disconnect the AC adapter or car adapter from 

the DC connector.



High density (dark) printing discharges the battery faster than low density 
printing. You can adjust the print density setting in the Printer Setting Tool 
(see the User's Guide).



The battery charging must take place between 41°F and 95°F (5°C and 
35°C) environments, otherwise the battery will not be charged. If the 
charging stops because the environment temperature is too low or too 
high, place your printer in an environment with a temperature between 
41°F and 95°F (5°C and 35°C) and try charging again.



If you use your printer when both the battery is installed and the AC 
adapter or car adapter is connected, charging may stop temporarily even 
if the battery is not fully charged.

To ensure the highest performance and longest life from the battery:



Do not use or store the battery in a location exposed to extreme high or low 
temperatures as it may deteriorate more quickly.



Remove the battery when storing your printer for long periods of time.



Store batteries with less than a 50% charge in a cool dry place out of direct 
sunlight.



Recharge the battery every six months if it is stored for long periods of 
time.



It is normal and safe for the printer to become warm while charging. 
Disconnect the charger and stop using the printer if it becomes hot to the 
touch.

Pull the cover open lever in the direction shown to open the media roll 

compartment cover.

Insert the media roll into the media roll compartment with the roll feeding 

from the bottom as shown.

Close the media roll compartment by pressing down on the center of the 

cover until it locks into place.

Pull the cover open lever in the direction shown to open the media roll 

compartment cover.

Open the roll guides by lifting up the roll guide adjustment lever and 

pulling the roll guide outwards. 



Insert the media roll into the media roll compartment with the roll feeding 

from the bottom as shown.

While lifting up the roll guide adjustment lever, push in both roll guides 

to the roll width. Insert the media roll so that it is positioned straight in 

the media roll compartment.

Close the media roll compartment by pressing down on the center of the 

cover until it locks into place.

On: Press and hold the   (Power) button until the LCD turns on.
Off: Press and hold the   (Power) button until the message [System Off] 

appears on the LCD.

1

Cover open lever

1

Print surface 



(faces outwards on the roll)

1

1

1

Cover open lever

1

Roll guide adjustment lever

2

Roll guide

3

Print surface 



(faces outwards on the roll)

Do NOT remove the battery until the LCD turns off.

1

1

1

2

2

3