Apple emac ati usb2 2005 서비스 매뉴얼

eMac ATI Graphics/ USB 2.0/2005 Take Apart - 95

Memory

Push the ejectors on the memory slot outward and down so they are in the open

position. Remove the memory module. Replacement Note: The memory is designed

to fit into the slot only one way. Be sure to align the notches on the module with the

small notches inside the slot.

Note: The RAM expansion modules used in the eMac (USB 2.0) computers are 184-pin

SDRAM DIMMs (dual inline memory modules) that are 2.5 V, unbuffered, 8-byte, non-

parity, and PC2700 compliant. The speed of the SDRAM devices must be rated at 167

MHz (7 ns) or faster. Refer to Kbase article 86718 for more information.

Important: The memory expansion cards (DIMMs) in the eMac (USB 2.0) computers

must use SDRAM devices as specified above. DIMMs for previous models of eMac or

DIMMs that use EDO or SGRAM devices will not work. If they are installed, the computer

will beep, and the power light will flash several times when you turn on the computer. This

indicates that the computer cannot find any useable RAM.