ademco vista-20p 사용자 설명서
– 18 –
Arming the System
(cont’d)
Arming Commands
Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.
message is displayed.
Mode
Press these keys…
Keypad Confirms By…
STAY
security code +
3
STAY
• three beeps
• armed STAY message displayed
• red ARMED indicator lights
• armed STAY message displayed
• red ARMED indicator lights
NIGHT-
STAY
STAY
security code +
3
STAY
+ 3
STAY
• three beeps
• NIGHT-STAY message displayed
• red ARMED indicator lights
• NIGHT-STAY message displayed
• red ARMED indicator lights
INSTANT security code +
7
INSTANT
• three beeps
• armed STAY message displayed
• red ARMED indicator lights
• armed STAY message displayed
• red ARMED indicator lights
Note that entry delay is turned off.
AWAY
security code +
2
AWAY
two beeps, or, if programmed, beeping for
duration of exit delay
• armed AWAY message displayed
• red ARMED indicator lights
• armed AWAY message displayed
• red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The keypad beeps
rapidly during the last 5 seconds of the
exit delay to warn you that it is ending.
door during the exit delay period to avoid
causing an alarm. The keypad beeps
rapidly during the last 5 seconds of the
exit delay to warn you that it is ending.
MAXIMUM security code +
4
MAX
• same as AWAY (described above)
Note that entry delay is turned off.
Quick Arming
If "Quick Arming" was programmed by the installer, the
If "Quick Arming" was programmed by the installer, the
[#]
key can be pressed in
place of the security code when arming the system in any of the arming modes.
However, the 4-digit security code must always be used to disarm the
system.
Function Key Arming
For any arming command, a function key may have also been programmed for your
system. If so, you can press and hold the appropriate function key for 2 seconds to
arm the system. See your installer for the designated functions (see
For any arming command, a function key may have also been programmed for your
system. If so, you can press and hold the appropriate function key for 2 seconds to
arm the system. See your installer for the designated functions (see
Single Button
Arming section).
Refer to the
Accessing Other Partitions section for information on multi-partition
arming (VISTA-20P/PS Series only).