Alcatel-Lucent OmniSwitch 9000 빠른 설정 가이드

8

Installing the Hardware

Note. Clearance is not required at the top and bottom of 

the chassis.

Refer to the important guidelines below before installing the 
OmniSwitch chassis in a rack.

Rack-mounting the chassis requires three people—two 

people to hold the chassis and position it in the rack and a 
third person to secure the chassis to the rack by using the 
attachment screws.

The chassis has two integral rack-mount flanges that 

support standard 19” rack mount installations. Refer to 

 for information on optional rack-mounting hard-

ware.

Alcatel-Lucent does not provide rack-mount screws. 

Use the screws supplied by the rack vendor.

To prevent a rack from becoming top heavy, it is recom-

mended that you install the switch at the bottom of the rack 
whenever possible.

If you are installing the switch in a relay rack, be sure to 

install and secure the rack per the rack manufacturer’s 
specifications.

 for important chassis airflow recom-

mendations before installing.

To rack-mount the switch, follow the steps below:

Mark the holes on the rack where the chassis is to be 

installed.

Using two people, lift and position the chassis until the 

rack-mount flanges are flush with the rack post.

Align the holes in the flanges with the rack holes you 

marked in step 1.

Once the holes are aligned, use a third person to insert 

a screw through the bottom hole on each flange. Tighten 
both screws until they are secure.

OmniS

wit

ch 9700

1

2

3

4

5

6

7

8

NI

NI

CMM

PWR

PS3

PS2

PS1

A

B