3com corebuilder 10002211 사용자 설명서

The following display shows all available multicast routes: 

 describes the fields in the route display.

Multicast Routing Table (2598 entries)
 Origin-Subnet      From-Gateway     Metric Tmr  In-If Out-Ifs
 157.88.29.1/32     137.39.229.98     18     25   T1    I1              
 137.39.2.254/32    137.39.229.98     5      25   T1    I1              
 131.215.125.236/32 137.39.229.98     14     25   T1    I1              
 130.118.106.254/32 137.39.229.98     10     25   T1    I1              
 129.127.118.12/32  137.39.229.98     10     25   T1    I1              
 129.127.110.12/32  137.39.229.98     10     25   T1    I1              
 129.127.110.11/32  137.39.229.98     13     25   T1    I1              
 129.127.110.5/32   137.39.229.98     10     25   T1    I1              
 129.95.63.12/32    137.39.229.98     13     25   T1    I1              
 129.95.63.11/32    137.39.229.98     31     25   T1    I1*             
 129.95.63.9/32     137.39.229.98     13     25   T1    I1              
 129.95.63.8/32     137.39.229.98     13     25   T1    I1              
 129.95.63.6/32     137.39.229.98     13     25   T1    I1              
 129.95.63.2/32     137.39.229.98     13     25   T1    I1              
 129.95.48.4/32     137.39.229.98     13     25   T1    I1              
 129.95.48.3/32     137.39.229.98     13     25   T1    I1              
 129.95.48.2/32     137.39.229.98     13     25   T1    I1              
 

Table A-1  Field Attributes for Multicast Route Display 

Origin-Subnet

The source address and the number of bits in the subnetwork

From-Gateway

The interface address of the gateway

Metric

The hop count

Tmr

The amount of time, in seconds, since the routing table entry was 
last reset

In-If

1

Interface number on which that gateway is connected. Traffic is 
expected to originate from this interface.

T

 represents the tunnel; P denotes that a prune has been sent to 

this tunnel.

Out-If

1

Set of interfaces that the traffic will be flooded out on. I repre-
sents the interface.

1

In-If and Out-If

Together, these attributes define a Spanning Tree configuration.
The system disables interfaces that comprise loops.