HP proliant dl580 사용자 설명서
Removal and replacement procedures 37
To replace the component, reverse the removal procedure.
Run RBSU to configure the server after replacing the battery. Refer to the HP ROM-Based Setup Utility User
Guide on the Documentation CD for more detailed information.
Guide on the Documentation CD for more detailed information.
Removing the media board
1.
Power down the server (on page
2.
Extend the server from the rack, if applicable ("
3.
Remove the access panel ("
4.
) and media drive blanks
5.
Disconnect all cabling from the media board.
6.
Loosen the thumbscrew, and slide the media board toward the front of the server to disconnect it
from the SCSI backplane.
from the SCSI backplane.
7.
Remove the media board.
To replace the component, reverse the removal procedure.
Removing the SCSI backplane
1.
Power down the server (on page
2.
) and media drive blanks
3.
4.
Extend the server from the rack, if applicable ("
5.
Remove the access panel ("
6.
Disconnect all cables from the SCSI backplane.
7.
Remove the media board ("