Canon fax-jx200 사용자 설명서

Sending Faxes

Before you send a document, see “Documents Requirements” on page 15, and “Loading Documents 
and Paper” on page 16.

„

Load the document face up into the Document Tray.

See “Loading Documents and Paper” on page 16.
You can set the scanning resolution and contrast (see page 20).

Dial the receiving party’s fax number.

Use one of the dialing methods described in this chapter.

Press [Start/Copy].

The fax begins sending.

„

If you would like to first speak with the person you are sending the document to, use manual 
sending.

Load the document face up into the Document Tray.

See “Loading Documents” on page 16.
You can set the scanning resolution and contrast (see page 20).

Pick up the Handset or press [Hook] and dial the receiving party’s fax number.

Use one of the dialing methods described in this chapter.

z

If paper jams, see “Troubleshooting” on page 53.

z

You can send up to 20 A4-size (10 legal-size) pages at a time (based on the Canon FAX Standard 

Chart No.1, standard resolution). You cannot add pages while the fax is sending.

z

The fax stores the document temporally in memory when sending a document, however, when memory 

is full, it will send the document as it scans the document without storing document in memory. 

z

If an error occurs during sending, the fax beeps intermittently for a few seconds and an error 

message appears on the LCD. If this happens, correct the problem and then press [Stop], then 

try sending the document again. See “LCD Messages” on page 62.

z

The fax automatically redials if the receiving party does not answer or if the line is busy. (You 

can specify the number of times it redials; see <AUTO REDIAL> on page 39.)

TEL=

3456xxxx

TEL=

3456xxxx