Sony CMT-SE9 사용자 설명서
42
GB
About recording errors
• With the following kinds of discs, you may
experience a reading failure or noise when
recorded on an MD:
recorded on an MD:
– Discs with adhesive labels attached to them
– Irregularly shaped discs (for example,
heart- or star-shaped)
– Discs with printed text concentrated on one
side only
– Scratched discs
– Dirty discs
– Warped discs
• If the following occurs during CD playback or
recording, a reading error may occur or noise
may be produced in the recorded results:
may be produced in the recorded results:
– The system is bumped.
– The system is placed on an uneven or soft
surface.
– The system is located near a speaker, door,
or other source of vibration.
• If the above reading errors occur, an extra
*1
For details on the limitations of digital recording,
see “Guide to the Serial Copy Management System”
on page 99. If you do not connect the DVD player to
MD deck with the supplied digital optical cable, the
MD deck only performs analog recording.
see “Guide to the Serial Copy Management System”
on page 99. If you do not connect the DVD player to
MD deck with the supplied digital optical cable, the
MD deck only performs analog recording.
*2
You cannot make a digital recording of sound
encoded by other than PCM mode. Set optional
digital components to PCM output.
encoded by other than PCM mode. Set optional
digital components to PCM output.
*3
Even if you connect a digital component, the MD
deck performs analog recording.
deck performs analog recording.
*4
TOC: Table Of Contents
After recording
Press
Z
MD on the MD deck to remove the
MD or press
?/1
(power) to turn off the
system.
“TOC” starts flashing. The TOC is updated and
recording is completed.
recording is completed.
Before pulling out the mains lead
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press
?/1
to
turn off the system. Do not pull out the mains
lead before updating the TOC or while updating
the TOC (while “TOC” lights up or flashes) to
ensure a complete recording.
lead before updating the TOC or while updating
the TOC (while “TOC” lights up or flashes) to
ensure a complete recording.
Protecting a recorded MD
• To protect a recorded MD, slide the tab on the
side of the MD to open the slot. In this
position, the MD cannot be recorded. To
record on the MD, slide the tab to close the
slot.
position, the MD cannot be recorded. To
record on the MD, slide the tab to close the
slot.
• If the MD is record protected, “C11” and
“Protected” appear alternately and the MD
cannot be recorded. Remove the MD, then
slide the record protection tab to the closed
position.
cannot be recorded. Remove the MD, then
slide the record protection tab to the closed
position.
Tab
Slide the tab