Panasonic WJ-HD200 사용자 설명서

25

■ Main Menu (WJ-HD200 MAIN

The main menu is located at the top of the menu tree from
where every menu window starts.

1. Hold down the [SETUP/ESC] button for 2 seconds. The

main menu appears.

2. Select a setup menu you wish to program using the [D]

or [C] button, and press the [SET] (JogDial).
The selected setup menu opens. The following pages
will detail each setup menu.

■ Timer Recording Setup (TIMER

This menu assigns a timer to start recording by use of an
external timer or the internal timer. When the internal timer
(INT) is set, there are four programs assignable to the
weekly and/or daily schedule. Each program can contain
up to four events along with start and end time, and record-
ing-mode. Alarm recording will be carried out when an
alarm operates within the scheduled time zone.
When the external timer (EXT) is set and the connected
timer switch turns on to supply power, the recorder will start
power-on recording.

1. Select a timer mode using the JogDial.

OFF: Does not use any timer, and manual recording is

available.

INT: Carries out internal timer recording according to

the program.

EXT: Carries out power-on recording.

2. Press the JogDial to validate the selection. When INT is

selected, the TIMER REC menu opens.

3. Move the cursor to the desired line using the [D] or 

[C] button.

4. Select any parameter from PROG1 to PROG4 using the

JogDial, and press the JogDial. The PROG1-4 SETUP
menu opens.

● Program "1-4" Setup (PROG1-4

1. Select the event number with the [D] or [C] button,

and press the JogDial. The cursor moves to the START
position. 
After this operation, the [D] and [C] buttons move the
cursor to the right and left.

2. Select a start time (START) using the JogDIal, and

press the [D] button to move to the next position.

Available START times: From 0:00 to 23:59 in the 24-

hour system.

3. Select an end time (END) in the same way as above

and press the [D] button to move the cursor to the
MODE position.

Available END times: From 0:01 to 24:00 in the 24-

hour system.

Notes: There are some restrictions on programming.

• An event, except the first event (NO 1), can be pro-

grammed only if the immediately preceding event
has been set up.

• The start time should be later than the end time of

the immediately preceding event. 

• The end time should be later than the start time of

the event.

• An end time set at 24:00 will cancel all following

events.

4. Press the JogDial while the cursor is on SET

O to open

the event programming menu.

O

O

O

O 

O 

O 

O 

O 

O 

→  8:00 12:20  SETO

→ 13:00 15:00  SETO

→   :     :

→   :     :

O