Panasonic WJ-HD200 사용자 설명서
● Built-in Motion Detector
The recorder detects motion for each of the eight video
inputs, based on certain changes in the video signal.
inputs, based on certain changes in the video signal.
● Built-in Video Loss Detector
The recorder detects any disconnection of the video inputs.
The images of the disconnected channel will not be record-
ed.
The images of the disconnected channel will not be record-
ed.
■ Alarm Output
The recorder performs the following actions when an alarm
is input.
is input.
● Front Panel Indicators
When an alarm is received, the ALARM indicator blinks and
the LED in the corresponding [CAMERA SELECT] button
blinks. More LEDs will blink when more alarm inputs arise.
The LED will stop blinking when the preset time has
elapsed (Auto Reset), when the [RESET] button is pressed
on the front panel (Manual Reset), when the external reset
signal is received on the rear panel (External Reset), or
when the video signal lost on any channel is restored
(Video Loss).
The ALARM indicator will change from blinking to a steady
light when Auto Reset or External Reset is implemented.
This steady light notifies the system operator that there
have been alarm activations that have not yet been manual-
ly reset.
the LED in the corresponding [CAMERA SELECT] button
blinks. More LEDs will blink when more alarm inputs arise.
The LED will stop blinking when the preset time has
elapsed (Auto Reset), when the [RESET] button is pressed
on the front panel (Manual Reset), when the external reset
signal is received on the rear panel (External Reset), or
when the video signal lost on any channel is restored
(Video Loss).
The ALARM indicator will change from blinking to a steady
light when Auto Reset or External Reset is implemented.
This steady light notifies the system operator that there
have been alarm activations that have not yet been manual-
ly reset.
ALARM
SUSPEND
RESET
CAMERA SELECT
1
5
2
6
3
7
4
8
44
• During the sequence, the LEDs of the [CAMERA
SELECT] buttons light up corresponding to the
selected cameras that send images to the monitor.
selected cameras that send images to the monitor.
Multiscreen monitor
Spot monitor
4. During the sequence, press the [SEQUENCE] button to
pause. The LED in the [SEQUENCE] button blinks.
5. Press the [SEQUENCE] button to restart the sequence.
The LED turns to a steady light.
6. Press any of the numeric buttons to quit the sequence
and return to spot monitoring.
Note: The Auto Skip function can be programmed in
Note: The Auto Skip function can be programmed in
the menu setup to be applied to the sequence to
skip any steps where no video signal is present.
skip any steps where no video signal is present.
Alarm Control Function
The recorder performs alarm functions to warn the system
operators when an event has occurred.
operators when an event has occurred.
■ Alarm Input
There are three alarm inputs to the recorder that allow the
recorder to output warnings.
recorder to output warnings.
● Connected Alarm Sensors
A maximum of eight sensors can be connected to the termi-
nals on the rear panel. Sensors may be installed in such
places as parking lots or reception desks where cars and
visitors come and go.
nals on the rear panel. Sensors may be installed in such
places as parking lots or reception desks where cars and
visitors come and go.
1
1
3
2
4
2
MULTISCREEN
SELECT
(4A)
1
1
2