Panasonic WJ-HD200 사용자 설명서

87

● When Error Indicator is Lit

Refer to your dealer for servicing when this happens.

8

The recorder checks the hard disk when the recorder is
turned on, or when the HDD CHECK time specified in
the menu setup comes during operation. 
The recorder warns you of any error detected as fol-
lows.

Error indicator blinks.
Warning Out terminal on the rear panel turns active.

"NO DISK" will appear when there is no disk installed in the
recorder.

When this happens, turn off the power. New disk(s) should
be installed on the recorder, referring to INSTALLATION.

8

1. Turn off the recorder, and turn it on again. It will perform

as follows.

DISK MENU is displayed.
Error indicator blinks.
Buzzer beeps every 5 seconds.

2. Press any buttons other than [STOP] to stop the indica-

tor blinking and buzzer beep.

3. See DISK MENU on the next page for further opera-

tions.

● When Full Indicator is Lit (Resetting

8

The FULL indicator will light up when STOP is set to
DISK END MODE, provided that the disk space nears
the end.
To reset it, do the following.

8

1. Hold down the [STOP] button for 2 seconds to open the

MAIN MENU.

2. Select SYSTEM SETUP, and press the JogDial to open

the SYSTEM SETUP menu.

3. Move the cursor to DISK END MODE, and rotate the

JogDial to select CONTINUE. Then press the JogDial.

STOP: Stops recording at the disk end.
CONTINUE: Overwrites from the start of the disk.

4. Press the [STOP] button to return to the MAIN MENU.

5. Hold down the [STOP] button for 2 seconds to return to

normal operations.
The recorder starts operating in continuous mode up to
the disk end.

If you wish the recorder to revert to STOP for DISK END
MODE, repeat above steps 1 through 5, but select
STOP in step 3.

O

O

O

O 

O 

O 

O 

O 

O 

→          ***** 

→    *****