Panasonic WJ-HD200 사용자 설명서

88

You can implement any of the following operations as necessary.

REMOVE LINK: Logically removes the HDD link.
HDD FORMAT: Formats the HDD.
RESTART: Closes the menu, and restarts the recorder.

The menu can also be displayed manually when you need to format the HDD or remove the logical link.

1. Turn off the power of the recorder once, and turn it on again. 

The multiscreen monitor displays the message "SYSTEM CHECK DONE! TO OPEN DISK MENU, PUSH STOP KEY".

2. Press the [STOP] button.

The DISK MENU opens. 

3. Select REMOVE LINK, HDD FORMAT, or RESTART.

Auto-remove
When no button is pressed for 5 minutes after opening the DISK MENU, the recorder will logically remove a disk that meets
any of the conditions below.

• An HDD has been categorized as " * ", "LOST", or "ERR".
• Restart was repeated 3 times due to writing error.

● DISK MENU

8

The menu appears if the hard disk error is found during
power-up.
The buzzer beeps every 5 seconds, and the ERROR
indicator turns off. 
Press any button other than [STOP] to mute the buzzer
beep.

The hard disk status and required operations are shown in the table.

→   SET→

→   SET→

→   SET→

Hard Disk Status

Operation

–

Format, remove link ,or replace HDD 
if erred even after formatting.

WR1 or WR2 appears in SYSTEM LOG
when indicating a writing error.

Normal status

Writing error

Same as above.

LOST or * status was left for

five minutes.

All existing HDD have been previously

used in another WJ-HD200.

Restart or Format

Awaiting format

HDD is removed without executing
REMOVE LINK command.

Remove link, or add a new HDD.

HDD physically removed

Format

HDD added, and awaiting

format

REMOVE LINK command has been
previously carried out.

Previous time and this time,
HDD physically or logically
removed