JVC GR-D650US 사용자 설명서

MasterPage: Start_Right

The audio track can be customized only when 
recorded in the 12-BIT and SP modes. 
(

●

Use the provided remote control. 

Play back the tape to locate the point where 

editing will start, then press PAUSE (

8).

While holding A. DUB (

) on the remote 

control, press PAUSE (

8). The “8 ” indicator 

appears.

Press PLAY (

3), then begin “narrating”. 

Speak into the microphone.

●

To pause dubbing, press PAUSE (

8

).

To end Audio Dubbing, press PAUSE (

8), 

then STOP (

7).

To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX”. 
(

●

Sound is not heard from the speaker during Audio 
Dubbing.

●

When editing onto a tape that was recorded at 
12-BIT, the old and new soundtracks are recorded 
separately.

●

If you dub onto a blank space on the tape, the 
sound may be disrupted. Make sure you only edit 
recorded areas.

●

If feedback or howling occurs during TV playback, 
move the camcorder’s microphone away from the 
TV, or turn down the TV’s volume.

●

If you change from 12-BIT to 16-BIT in mid-
recording and then use the tape for Audio 
Dubbing, it is not effective from the point where 
16-BIT recording began.

●

During Audio Dubbing, when the tape moves to 
scenes recorded in the LP mode, scenes 
recorded in 16-BIT audio or a blank portion, Audio 
Dubbing stops. 

You can record a new scene into a previously 
recorded tape, replacing a section of the original 
recording with minimal picture distortion at the in 
and out points. The original audio remains 
unchanged.

●

Use the provided remote control.

●

Before performing the following steps, make sure 
that “TIME CODE”” in both Recording and 
Playback Menus is set to “ON”. (

●

Insert Editing is not possible on a tape recorded in 
the LP mode or on a blank portion of a tape.

Play back the tape, locate the Edit-Out point 

and press PAUSE (

8). Confirm the time code at 

this point. (

Press REW (

1) until the Edit-In point is 

located, then press PAUSE (

8).

Press and hold INSERT (

) on the remote 

control, then press PAUSE (

8). The “8 ” 

indicator and the Time Code (min.:sec.) appear 
and the camcorder enters Insert-Pause mode.

Press START/STOP to begin editing.

●

Confirm the insert at the time code you checked in 
step 

1.

●

To pause editing, press START/STOP. Press it 
again to resume editing.

To end Insert Editing, press START/STOP, 

then STOP (

7) on the remote control.

●

Program AE, Effects and Shutter Effects 
(

being edited during Insert Editing.

●

During Insert Editing, the date and time 
information changes.

●

If you perform Insert Editing onto a blank space 
on the tape, the audio and video may be 
disrupted. Make sure you only edit recorded 
areas.

●

During Insert Editing, when the tape moves to 
scenes recorded in the LP mode or a blank 
portion, Insert Editing stops. (

GR-D650US.book  Page 45  Monday, February 27, 2006  9:38 AM