Toshiba ASD-G9ETH 사용자 설명서

 

  

20

ICC 

5.  In the dialog that appears, select Manually configure network settings. 

6.  Enter the desired IP Address, Subnet Mask, Default Gateway and case-

sensitive system password (default is “icc”) in the appropriate boxes, then 
click Apply. 

7.  A popup dialog box will prompt you to reboot.  Click Reboot Device.  

Rebooting may require 30s or more to complete.  When the device status 
indicates “Ready”, click Close. 

8.  The discovery utility will automatically rescan the network.  Confirm that the 

new IP address has been accepted by the device. 

 
 

This section applies to G9 (drive control board firmware V203R5 and later) and 
H9 (drive control board firmware V204R4) drives only. 
 
The interface card’s IP Address, Subnet Mask, Default Gateway, and 
DHCP/Static IP mode can be viewed and modified via the drive’s keypad by 
navigating to Program…Communications…Ethernet Settings.  Additionally, the 
interface card’s unique MAC ID can be viewed (but not modified) in this screen. 
 
Note that these parameter values are read by the interface card only during 
initial boot-up.  Therefore, be sure to power cycle the drive whenever any of 
these values are changed to allow the changes to take effect. 
 
 

Once an initial IP address has been assigned to the device and the 
configuration web page can be accessed, the IP address-related parameters 
can also be modified via the web page.  Refer to section 10.7.5.