Yamaha AG-Stomp 사용자 설명서

Using the AG-Stomp

First, connect your guitar to the AG-Stomp and try to get some sound.

OFF (

)

■ Connecting the Guitar

Before making any connections, make sure the AG-Stomp’s power is off, set the AG-Stomp’s OUTPUT
knob to “0” and the +9V SUPPLY switch to “OFF”. Then connect the INPUT jack on the rear panel to the
guitar’s output jack with any commercially available guitar cable (monaural

↔ monaural).

Never connect the guitar to the AG-Stomp with the supplied TRS phone cable when the Guitar Power Supply
function described below is not used. If the TRS phone cable is used and the +9V SUPPLY switch is switched
“ON”, it may result in damage since a total of 18V will be supplied to the electric-acoustic guitar’s built-in pre-
amplifier. Also, if the +9V SUPPLY switch is set to “OFF”, the electric-acoustic’s built-in pre-amplifier may func-
tion abnormally.

● Guitar Power Supply

Before supplying power to your guitar, make sure
that the guitar’s pre-amplifier battery has been re-
placed with the dummy battery supplied with the
AG-Stomp. Leaving the 006P 9V battery in place will
result in the guitar’s electronics receiving 18V of
power, causing damage.

The AG-Stomp is capable of supplying power to your elec-
tric-acoustic guitar’s built-in pre-amplifier via the supplied
TRS phone cable. Power is supplied to the electric-acoustic
guitar when the AG-Stomp’s power is switched ON.
This function is possible as long as your electric-acoustic
guitar meets the following conditions:

• The guitar uses a monaural output.
• The guitar uses a 006P 9V battery to supply power

to the guitar’s built-in pre-amplifier.

• The power to the guitar’s built-in pre-amplifier is

switched ON/OFF by connecting/disconnecting the
cable at the guitar’s jack.

• The guitar’s built-in electronics consume 10mA of

power, or less.

[Setting]
1. Replace the electric/acoustic guitar’s built-in pre-ampli-

fier battery with the dummy battery supplied with the
AG-Stomp.

2. Before making any connections, turn off the AG-Stomp’s

power and make sure its OUTPUT knob is set to “0”,
then set the +9V SUPPLY switch to “ON”.

3. Use the supplied TRS phone cable to connect the AG-

Stomp’s INPUT jack to the output jack on your electric/
acoustic guitar.

* When the AG-Stomp’s power is ON, make sure that the MUTE

switch on the AG-Stomp is held down when connecting/dis-
connecting the cable.

* Do not connect effectors, etc., between the AG-Stomp’s IN-

PUT jack and the electric-acoustic guitar’s OUTPUT jack.
Power will not be supplied to the electric-acoustic guitar’s
built-in pre-amplifier if the AG-Stomp and the electric-acoustic
guitar are not directly connected.

Replace the electric-
acoustic guitar’s pre-
amplifier battery with the
dummy battery.

Dummy Battery
(supplied)

TRS Phone Cable (supplied)

Set the +9V SUPPLY
switch to the “ON”
position.

If the AG-Stomp’s power
is ON, hold the MUTE
switch when making
connections.