Epson emp 800 사용자 설명서

다운로드
페이지 106
Using Optional Interfaces
A-3
Installing Optional Interfaces 
Before you install an optional interface board in your printer, 
make sure the printer is turned off and all the printer’s lights are 
off. Then follow these steps:
1. Unplug the power cord from the electrical outlet (and from 
the back of the printer, if your printer’s power cord is 
removable).
2. Turn the printer around so that its back faces you, and 
disconnect any interface cables.
3. Use a cross-head screwdriver to remove the two screws 
securing the shield plate to the interface slot; then lift off 
the plate. Be sure to keep both screws; you may need to use 
them again when you reinstall the shield plate.
4. Be sure to set any switches and jumpers on the board. See 
the interface board’s manual for details. If your board has a 
jumper labeled JG, make sure that you set it to on, or the 
board will not work properly.
Caution:
To avoid damaging your 
printer or computer, do 
not install the interface 
board when the printer is 
connected to an electrical 
outlet. 
easapa.fm5  Page 3  Tuesday, January 14, 1997  9:47 AM