Siemens Gigaset C450IP 사용자 설명서

다운로드
페이지 106
36
SMS (text messages)
Gigaset C450 IP / Greek eng / A31008-M1713-T151-3-8U19 / sms_neutral.fm / 24.9.07
Ver
si
on 4, 16.
09.20
05
Adding a number to the directory
Adding the sender's number
You are reading an SMS in the incoming 
message list. 
§Menu§
Press the soft key.
For further information, see page 30
Setting SMS centre
You can set up a maximum of four SMS 
centres. 
Entering/changing SMS centres
¤
You should find out about the services 
and special functions offered by your 
service provider before you make a 
new application and before you delete 
preconfigured phone numbers. 
§Menu§
 
¢
SMS 
¢
Settings 
¢
Service 
Centres
q
Select SMS centre (e.g. 
Service 
Centre 1
) and press 
§OK§
.
You have the following options:
Active Send Serv. Centre
If the SMS messages are to be sent 
through this SMS centre, press 
§OK§
 to 
activate the SMS centre (
‰ = on).  If  a 
different SMS centre was active previ-
ously, then this will be deactivated. 
With SMS centres 2, 3 and 4, the set-
ting only applies to the next SMS. 
SMS
Enter the number of the SMS centre 
and press 
§OK§
.
Sending an SMS through another SMS 
centre
¤
Activate the SMS centre (2 or 3) as the 
active send service centre (page 36). 
¤
Send the SMS. 
This setting only applies to the next SMS 
to be sent. After that, the setting returns 
to 
Service Centre 1
.
SMS on a PABX
u You can only receive an SMS when the 
Calling Line Identification (page 19) 
is forwarded to the extension of the 
PABX (CLIP). The CLIP of the phone 
number for the SMS centre is evaluated 
in your Gigaset.
u Depending on your PABX, you may 
have to add the access code (external 
line prefix) before the number of the 
SMS centre.
If in doubt, test your PABX e.g. by send-
ing an SMS to your own phone number, 
once with and once without the access 
code. 
u When you send SMS messages, your 
sender number may be sent without 
your extension number. In this case the 
recipient cannot reply to you directly.
Sending and receiving SMS on ISDN 
PABXs is only possible via the MSN 
number assigned to your base station. 
Activating/deactivating the SMS 
function
When you switch off you cannot send or 
receive any SMS messages with your 
phone.
Settings which you have made for sending 
and receiving SMS messages (the num-
bers of SMS centres) and any entries in the 
incoming message and draft message lists 
will be retained even after the function is 
deactivated. 
Please note:
You can create a special directory for SMS mes-
sages within your main directory by putting a 
star (*) before the names. 
An appended mailbox ID will be copied to the 
directory.