Alliance Laundry Systems 1305 사용자 설명서

51

F232120

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

The following are instructions for installing/removing 
the Program Keypad Module (P/N F370851) for 
parameter viewing and basic troubleshooting. Refer to 
Table 31.

1. Remove power from the machine at main 

disconnect. Delay approximately three minutes.

2. Insert a small screwdriver into slot, pry back, and 

remove status display cover. Refer to Figure 30.

3. Insert the PKM bottom end first and then press 

the symbol 

at the top of the module until the 

module is fully seated. The module is fully seated 
when its face is flush with the edges of its 
surrounding case.

1. Remove power from the machine at main 

disconnect. Delay approximately three minutes.

2. Insert small screwdriver into slot, pry back, and 

pivot module out. Avoid bending or twisting 
contact pins located underneath center portion of 
the module (Figure 30).

3. Reinstall the status display cover.

W673

W662