Alliance Laundry Systems 1305 사용자 설명서

Allen-Bradley 160-Series AC Drives

F232120

Viewing a Display Group

(Parameters #1 – 16 for Series A & B or
Parameters #1 – 19 for Series C)

1. Install PKM on A-B 160 drive. Refer to

“Installation/Removal”.

2. Turn on machine power.

3. Select the desired parameter by pressing the Up

and Down arrow keys

. The parameter

value is shown in the last four digits of the
display.

Viewing a Program Group

(Parameters #30 – 80 for Series A & B or
Parameters #30 – 86 for Series C)

1. Install PKM on A-B 160 drive. Refer to

“Installation/Removal.”

2. Turn on machine power.

3. The PKM begins in Display. Press the ESC key

to enter the Program Group.

NOTE: Confirmation of the mode is presented by a
decimal point after the second parameter digit.

4. Parameter #30 should be displayed if entering the

program group for the first time.

5. From this point, parameters #30 – 80 can be

viewed by pressing the Up and Down arrow keys

6. To exit the Program Group, press the

ESC key

Display Mode Parameter Set

CAUTION

Users are prohibited from changing
parameter values unless specifically
instructed by the washer-extractor
manufacturer. Modification to parameter
values may present potential harmful
operating conditions for both hardware and
personnel.

W673

ESC

Output Frequency

Output Voltage

Output Current

Output Power

Bus Voltage

Frequency Command

Last Fault

Heatsink Temperature

Controller Status

Controller Type

Control Version

Input Status

Power Factor Angle

Memory Probe Address

Preset Status

Balance Angle

*17

Fault Buffer 0

*18

Fault Buffer 1

*19

Fault Buffer 2

Table 33