Patton electronic smartnode 4110 사용자 설명서
3 • Installation
Model 4520 & 4110 Series Getting Started Guide
38
Installing the gateway router
Installing the Ethernet cable
The SmartNode 4520 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see
The SmartNode 4520 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see
). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ethernet ports
for port pin-out listing) via a cable terminated with RJ-45 plugs. A cross-over cable is only required
when connecting SmartNode 4110 Series devices to a host (see
Note
Pins not listed are not used.
Figure 17. Connecting to a hub
Table 8. Ethernet 10/100Base-T (RJ-45) port pin-outs
Pin
Signal
1
TX+
2
TX-
3
RX+
6
RX-