Patton electronic forefront 2616rc 사용자 설명서

Using a browser to complete Model 2616RC configuration

Model 2616RC T-DAC User Manual 

•

Hard Reset—this button (see 

) causes the Model 2616RC to perform a cold restart. When you 

select Hard Reset, the T-DAC confirms that you want to execute this command. Then, the T-DAC will 
disconnect all current sessions, re-initialize the interfaces, and re-load configuration parameters from 
FLASH.

•

Set Factory Default Configuration—this button (see 

) clears out the configuration in FLASH and 

loads the factory default parameters into FLASH memory. The factory default settings will not execute on 
the Model 2616RC until it is re-booted by doing a Hard Reset.

Set Factory Default Configuration (

) will delete any routing 

information, the Model 2616RC’s Ethernet IP address, and any other 
site-specific settings made for your particular installation. You will 
have to re-enter the Model 2616RC’s Ethernet IP address and net-
mask using the rear panel control port before using the 
HTTP/HTML Management pages.

The default gateway IP address, if defined, is used solely for managing the 2616RC remotely via the Ethernet 
port. The 2616RC does not transmit or receive user data nor any other traffic via the default gateway IP 
address or the Ethernet port.

Do the following to add the default gateway:

1. On the 2616RC Configuration Menu, click the IP hyperlink to open the IP Configuration page.

2. Click the Routing Info hyperlink to open the IP Routing Information page (

Figure 27. IP Routing Information Page

3. The existing route you see in the table is the LAN IP address you assigned to the 2616RC during initial 

configuration through the RS-232 control port, earlier in this chapter.

4. To enter the default gateway, use the first 

. The Destination shall remain 0.0.0.0, and there 

is no mask to enter.