Zenith 12 사용자 설명서
For exposures longer than the meter range (1/30th at f/2)
the "B" setting on the Speed Dial [1] must be used. The
exposure should be determined by using a hand-held
meter such as the Leningrad or by experience/estimation.
the "B" setting on the Speed Dial [1] must be used. The
exposure should be determined by using a hand-held
meter such as the Leningrad or by experience/estimation.
Although the camera may be rested on a firm surface the
best results will be obtained by the use of a tripod but
avoid those of a flimsy nature. A Hellos Tripod or Hellos
Mini-Tripod (illustrated) is ideal.
best results will be obtained by the use of a tripod but
avoid those of a flimsy nature. A Hellos Tripod or Hellos
Mini-Tripod (illustrated) is ideal.
Set the Speed Dial to "B"
Set the Aperture Ring [9]. Focus and cock shutter by
advancing Film Transport Lever [2] in short strokes until it
stops.
advancing Film Transport Lever [2] in short strokes until it
stops.
Fit a short cable release (obtainable from any good dealer)
into the screwed portion of the camera's Shutter Release
Button [3]. Depress the cable release and the shutter will
stay open until pressure is released. Some cable releases
have a screw lock which avoids the need for holding it
during a lengthy exposure.
into the screwed portion of the camera's Shutter Release
Button [3]. Depress the cable release and the shutter will
stay open until pressure is released. Some cable releases
have a screw lock which avoids the need for holding it
during a lengthy exposure.
If you do not have a cable release depress the camera's
Shutter Release Button until the shutter opens and turn it
fully anti-clockwise to the "T" position. The shutter will
remain open until the button is returned to the normal
position. We recommend the use of a cable release where
possible as this will reduce the chance of "camera shake"
during the exposure.
Shutter Release Button until the shutter opens and turn it
fully anti-clockwise to the "T" position. The shutter will
remain open until the button is returned to the normal
position. We recommend the use of a cable release where
possible as this will reduce the chance of "camera shake"
during the exposure.