Maytag w10577942b 사용자 설명서

NOTE: The control panel features a sensitive surface that 

responds to a light touch of your finger. To ensure your selections 

are registered, touch the control panel with your finger tip, not 

your fingernail. When selecting a setting or option, simply touch 

its name.

Touch to activate additional wash  

options or additional features on the washer.

Touch and hold for 3 seconds to lock the controls  

to avoid unwanted changes or operation. Touch and hold 

3 seconds again to unlock. You can still touch HOLD TO 

START to pause the cycle, or touch POWER to turn the 

washer off.

This compartment holds liquid or powdered HE detergent 

for your main wash cycle. 

Automatically dilutes and dispenses liquid fabric softener 

at the optimum time in the cycle.

n

 

Use only liquid fabric softener in this dispenser.

Automatically dilutes and dispenses liquid chlorine bleach 

at the optimum time during the first rinse after the wash 

cycle. This compartment cannot dilute powdered bleach.

The dispenser drawer gives you the convenience of  

automatically adding HE detergent, liquid chlorine bleach, 

and liquid fabric softener to the wash load at the proper time. 

See “Using the Dispenser Drawer” for information on using  

the dispenser drawer. 

HE detergent

 Liquid  fabric   
softener
Chlorine bleach

Touch to turn the washer on and off. Touch to stop/cancel  

a cycle at any time. 

Use your Wash Cycle knob to select available cycles on your 

washer. Turn the knob to select a cycle for your laundry load. 

An LED will light up for the cycle selected. 
NOTE: The Clean Washer LED will flash when the washer 

has run 30 wash cycles as a reminder to run the Clean 

Washer cycle. 
See “Cycle Guide” for detailed descriptions of cycles.

Touch and hold until the light above HOLD TO START comes 

on to start a cycle, or touch once while a cycle is in process to 

pause it. If you want to add a garment, you can touch HOLD 

TO START when the “Add a Garment” LED is on.

Use 

+ and – to delay the start of the wash cycle by up to  

8 hours. To turn off Delay Wash, use 

+ and – to set the delay 

time to “0,” or touch POWER.

When you select a cycle, its default settings will light up and 

the Estimated Time Remaining will be displayed (for times 

longer than 99 minutes, hours will be displayed, followed 

by minutes). Factors such as load size, wash temperature, 

and water pressure may affect the time shown in the display 

during the cycle. Tightly packing garments, unbalanced loads, 

or excessive suds may cause the washer to adjust the cycle 

time, as well. 
Touch the desired option along the bottom of the display to 

adjust settings. See “Cycle Guide” for available settings on 

each cycle. Not all settings are available with all cycles.

For details, see “Cycle Status Lights”.
Wash Temp 

The recommended wash temperature is preset for each 

cycle. You may also select a wash temperature based 

on the type of fabric and soils being washed. For best 

results, follow the garment label instructions. All wash 

temperatures feature a cold rinse.
Spin

This washer automatically selects the spin speed based on 

the cycle selected. Some preset speeds can be changed. 
•  Faster spin speeds mean shorter dry times, but may  

increase wrinkling in your load. 

•  Slower spin speeds reduce wrinkling, but will leave  

your load more damp.