Kurzweil pcx1inst 사용자 설명서
The Polyphony Expansion Kit
Installing in Rack-Mount Models
17
4. Snap the PCX-1 board onto each of the four standoffs, one at a time, by pressing on the
board near the location where each standoff protrudes through the board. You should
both feel and hear the board snap into each standoff.
both feel and hear the board snap into each standoff.
5. Thread the two screws through the holes in the right edge of the PCX-1 board and into the
standoffs under the board. Tighten the screws with a #1 Phillips screwdriver. Tighten
them only until snug; do not overtighten.
them only until snug; do not overtighten.
Reassembly and Verification
1. Slide the top panel back into place, and replace the seven retaining screws.
2. Turn the PC2R on, and watch the display. It should show
Welcome|to|the|PC2rp
, then
go to a performance mode. If you don’t see the
p
in the instrument name, the PCX-1 board
is not installed properly, and you should repeat the installation procedure or consult a
Kurzweil dealer or service center.
Kurzweil dealer or service center.